Now you see him.
Griffin spent his whole career trying not to be seen. We put him on the one part of your board everybody looks at. Tim Baron’s Invisible Man takes over a full sheet of grip, so the top of your setup finally gets the same monster treatment as the bottom.
It’s printed on Jessup Ultragrip, the tape skaters have trusted for decades, so it isn’t a novelty sheet that goes bald in a week. It locks your feet in, lays down clean, and trims easy.
Pair it with a Griffin deck for the full mad-scientist setup, or put it on whatever you’re riding and let him haunt it.
The details
- Original Griffin Invisible Man artwork by Tim Baron
- Printed on genuine Jessup Ultragrip griptape
- One sheet, 9" x 33", which covers decks up to 9" wide
- Aggressive silicon carbide grit for extra traction
- Jessup griptape made in the USA
- Small-batch run, and when it’s gone, it’s gone
How to apply it
- Peel the backing and line the graphic up where you want it before you commit.
- Lay it down from the center out, pressing out bubbles as you go.
- Score the edge of the deck with a file or screwdriver shaft to mark your cut line.
- Trim with a fresh razor blade, then sand the edges with a scrap piece of grip.
- Poke your hardware holes from the top and bolt up.
A heads up on printed grip
Graphic griptape wears where your feet live. The art will fade and scuff in your stance over time, which is normal. Griffin would probably prefer it that way.
FAQ
Will this fit my board? One sheet is 9" x 33", so it covers standard popsicles and most shaped decks up to 9" wide. For anything wider or longer, measure first.
Does printed grip hold as well as plain black? Yes. It’s Jessup Ultragrip under the ink, so you’re getting real skate grip.
Does it come installed? No. The sheet ships on its own and we don’t install grip, so you’ll be applying it yourself. The steps above walk you through it, and it takes about ten minutes.